Find out what caused your iron to leak

Steam irons help speed faster ironing flat clothes iron dry 2-3 times and ironed the most stubborn wrinkles. However, this household appliance often experiences a water leak that makes it difficult to use. So what is the cause of your iron leaking water ? And how to fix it?

Iron is not hot enough

After we plug our iron into the power source, we often think that it can be ironed right away. However, this is a bad habit when using a steam iron . When just connected to the power source, the iron has not heated up in time, the temperature is not enough to boil the amount of pre-filled water. Water cannot evaporate. When the table tilts the iron, the water will flow back to the outside.

Wait about 5 minutes after plugging in before you start using your iron.

To avoid this, wait about 5 minutes after plugging in before you start using your iron. This not only helps you get the most out of your steam iron, but also prevents water from falling into the electrical outlet. This routine helps to avoid unfortunate electrical accidents and protects your iron for longer use.

Iron is not clean

Do not think that your iron will not be dirty. After a long period of operation, the steam spray holes and the water canister will be attached to dirt, thereby blocking the steam escape when you use the product's spray function. So there is a situation in which the iron is leaking water .

Unclean steam iron can also cause water leaks.

To remedy this, you should regularly clean the iron. It's not that taking your iron soaked in water and scrubbing it, it will cause a short circuit. Simply wipe the soleplate with a damp cloth, then adjust the built-in self-cleaning mode on your iron. The device will automatically remove the residue in the steam vents.

The water in the tube is too much

This is the most common cause by many users. When adding water, you usually allow water to exceed the indicated Max. If the water is too full, it will overflow when you close the lid. This causes water leakage and electric shock.

Be sure to fill the iron with water in moderation.

Therefore, make sure you pour water in moderation and use a towel to dry the exterior and soleplate of the iron before plugging it in in case water spills over. One thing especially note, you should only put water in the container, absolutely not for perfumes or fragrances. Because in their composition, they contain chemicals that can damage the device inside if leaked.

Reuse previously excess water

Excess water, when not in use for a while, will evaporate and close the dirt inside, especially when you use tap water with a lot of impurities.

Therefore, manufacturers often recommend using purified water or cool boiled water to fill the water tube. After each use, you should empty the excess water and refill it completely new next time.

These are all causes of iron leaks that are easy to encounter during use and you can fix them easily. Some reasons stem from the manufacturer's technical fault, you should bring the iron to the warranty company or to the electronics center that you bought to get repaired. Avoiding self-repairing at home will cause unfortunate situations in being unfortunate.